EagleCAD PCB
From Attie's Wiki
(Difference between revisions)
m (→Doing a Polygon pour) |
m (→Step 7 - Click on an edge of the polygon) |
||
(2 intermediate revisions by one user not shown) | |||
Line 20: | Line 20: | ||
===Step 6 - Get the 'Info' tool=== | ===Step 6 - Get the 'Info' tool=== | ||
[[File:Eagle-Pour-Step6.png]] | [[File:Eagle-Pour-Step6.png]] | ||
− | ===Step 7 - | + | ===Step 7 - Click on an ''edge'' of the polygon=== |
[[File:Eagle-Pour-Step7.png]] | [[File:Eagle-Pour-Step7.png]] | ||
+ | * You have to click on the edge, if you can't see the edge (it's dodging lots of stuff) then you need to pretend that you can! | ||
* Set the isolation to a reasonable value, say 0.024 inches | * Set the isolation to a reasonable value, say 0.024 inches | ||
* Uncheck 'Thermals' (this isolates each pad, but creates little traces in) | * Uncheck 'Thermals' (this isolates each pad, but creates little traces in) | ||
+ | |||
===Step 8 - Ratsnest!=== | ===Step 8 - Ratsnest!=== | ||
[[File:Eagle-Pour-Step8.png]] | [[File:Eagle-Pour-Step8.png]] |
Latest revision as of 21:08, 7 September 2012
[edit] Getting the airwires to follow the shortest routes
Press the 'Ratsnest' button
[edit] Resolving the last (few) airwires
Set "Catch factor" to 100% (default: 5%)
Options → Set → Misc → Catch factor
[edit] Making a Polygon pour
[edit] Step 1 - Layout your circuit
[edit] Step 2 - Layout your PCB
[edit] Step 3 - Route your PCB
[edit] Step 4 - Get the 'Polygon' tool
[edit] Step 5 - Make your polygon (ground plane in this case)
[edit] Step 6 - Get the 'Info' tool
[edit] Step 7 - Click on an edge of the polygon
- You have to click on the edge, if you can't see the edge (it's dodging lots of stuff) then you need to pretend that you can!
- Set the isolation to a reasonable value, say 0.024 inches
- Uncheck 'Thermals' (this isolates each pad, but creates little traces in)
[edit] Step 8 - Ratsnest!
[edit] Step 9 - Oh No
- The ground plane has gone in, and is avoiding the traces... but its also avoiding the ground trace.
[edit] Step 10 - Get the 'Name' tool
[edit] Step 11 - And check the name of the ground trace
- You of course probably named this in your schematic, something sensible like 'GND'