Xbee default
From Attie's Wiki
(Difference between revisions)
m |
m |
||
| Line 10: | Line 10: | ||
ATRE | ATRE | ||
ATBD6 | ATBD6 | ||
| + | ATGTFA | ||
ATWR | ATWR | ||
ATFR | ATFR | ||
| Line 30: | Line 31: | ||
ATRE | ATRE | ||
ATBD6 | ATBD6 | ||
| + | ATGTFA | ||
ATWR | ATWR | ||
ATFR | ATFR | ||
| Line 52: | Line 54: | ||
ATRE | ATRE | ||
ATBD6 | ATBD6 | ||
| + | ATGTFA | ||
ATWR | ATWR | ||
ATFR | ATFR | ||
Latest revision as of 11:45, 11 June 2010
Follow the below sequence to set an XBee to good default settings:
Note: When changing channels you should always connect directly to the XBee and always write (ATWR) and reset (ATFR) immediately otherwise it tends to wander off!
use ATSH and ATSL to get the local XBee address
Contents |
for general purpose
+++ ATRE ATBD6 ATGTFA ATWR ATFR +++ ATCH_ ATMYFFFF ATDN_ ATNI_ ATD50 ATD70 ATAP2 ATWR ATFR
for wireless arduino programming
pc end
+++ ATRE ATBD6 ATGTFA ATWR ATFR +++ ATCH_ ATMYFFFF ATDH_ ATDL_ ATNI_ ATD33 ATD50 ATD70 ATIC8 ATIU0 ATWR ATFR
arduino end
+++ ATRE ATBD6 ATGTFA ATWR ATFR +++ ATCH_ ATMYFFFF ATDH_ ATDL_ ATNI_ ATRO1 ATT31 ATD35 ATD50 ATD70 ATIU0 ATIAFFFF ATWR ATFR
