Xbee default
From Attie's Wiki
(Difference between revisions)
m |
m |
||
| Line 15: | Line 15: | ||
ATCH_ | ATCH_ | ||
ATMYFFFF | ATMYFFFF | ||
| + | ATDN_ | ||
ATNI_ | ATNI_ | ||
ATD50 | ATD50 | ||
| Line 33: | Line 34: | ||
+++ | +++ | ||
ATCH_ | ATCH_ | ||
| + | ATMYFFFF | ||
ATDH_ | ATDH_ | ||
ATDL_ | ATDL_ | ||
| − | |||
ATNI_ | ATNI_ | ||
ATD33 | ATD33 | ||
| Line 52: | Line 53: | ||
+++ | +++ | ||
ATCH_ | ATCH_ | ||
| + | ATMYFFFF | ||
ATDH_ | ATDH_ | ||
ATDL_ | ATDL_ | ||
| − | |||
ATNI_ | ATNI_ | ||
ATRO10 | ATRO10 | ||
Revision as of 21:11, 26 March 2010
Follow the below sequence to set an XBee to good default settings:
Note: When changing channels you should always connect directly to the XBee and always write (ATWR) and reset (ATFR) immediately otherwise it tends to wander off!
use ATSH and ATSL to get the local XBee address
Contents |
for general purpose
+++ ATRE ATBD6 ATWR ATFR +++ ATCH_ ATMYFFFF ATDN_ ATNI_ ATD50 ATD70 ATAP2 ATWR ATFR
for wireless arduino programming
pc end
+++ ATRE ATBD6 ATWR ATFR +++ ATCH_ ATMYFFFF ATDH_ ATDL_ ATNI_ ATD33 ATD50 ATD70 ATIC8
arduino end
+++ ATRE ATBD6 ATWR ATFR +++ ATCH_ ATMYFFFF ATDH_ ATDL_ ATNI_ ATRO10 ATT31 ATD35 ATD50 ATD70 ATIU0 ATIAFFFF
