Xbee default
From Attie's Wiki
(Difference between revisions)
| Line 1: | Line 1: | ||
Follow the below sequence to set an XBee to good default settings: | Follow the below sequence to set an XBee to good default settings: | ||
| + | {{note|When changing channels you should always connect directly to the XBee and always write (ATWR) and reset (ATFR) immediately otherwise it tends to wander off!}} | ||
| + | |||
| + | <h2>for general purpose</h2> | ||
<pre> | <pre> | ||
+++ | +++ | ||
| Line 8: | Line 11: | ||
ATFR | ATFR | ||
+++ | +++ | ||
| + | ATCH_ | ||
ATMYFFFF | ATMYFFFF | ||
ATNI_ | ATNI_ | ||
| − | |||
ATD50 | ATD50 | ||
ATD70 | ATD70 | ||
| Line 18: | Line 21: | ||
</pre> | </pre> | ||
| − | + | <h2>for wireless arduino programming</h2> | |
| + | <h3>pc end</h3> | ||
| + | <pre> | ||
| + | +++ | ||
| + | ATRE | ||
| + | ATBD6 | ||
| + | ATWR | ||
| + | ATFR | ||
| + | +++ | ||
| + | ATCH_ | ||
| + | ATDH_ | ||
| + | ATDL_ | ||
| + | ATMYFFFF | ||
| + | ATNI_ | ||
| + | ATD33 | ||
| + | ATIC8 | ||
| + | </pre> | ||
| + | |||
| + | <h3>arduino end</h3> | ||
| + | <pre> | ||
| + | +++ | ||
| + | ATRE | ||
| + | ATBD6 | ||
| + | ATWR | ||
| + | ATFR | ||
| + | +++ | ||
| + | ATCH_ | ||
| + | ATDH_ | ||
| + | ATDL_ | ||
| + | ATMYFFFF | ||
| + | ATNI_ | ||
| + | ATRO10 | ||
| + | ATD35 | ||
| + | ATIU1 | ||
| + | ATIAFFFF | ||
| + | ATT31 | ||
| + | </pre> | ||
Revision as of 15:04, 25 March 2010
Follow the below sequence to set an XBee to good default settings:
Note: When changing channels you should always connect directly to the XBee and always write (ATWR) and reset (ATFR) immediately otherwise it tends to wander off!
Contents |
for general purpose
+++ ATRE ATBD6 ATWR ATFR +++ ATCH_ ATMYFFFF ATNI_ ATD50 ATD70 ATAP2 ATWR ATFR
for wireless arduino programming
pc end
+++ ATRE ATBD6 ATWR ATFR +++ ATCH_ ATDH_ ATDL_ ATMYFFFF ATNI_ ATD33 ATIC8
arduino end
+++ ATRE ATBD6 ATWR ATFR +++ ATCH_ ATDH_ ATDL_ ATMYFFFF ATNI_ ATRO10 ATD35 ATIU1 ATIAFFFF ATT31
