OpenOCD
From Attie's Wiki
(Difference between revisions)
m (→Usage) |
m (→Usage) |
||
Line 39: | Line 39: | ||
{| | {| | ||
− | | halt || halt... | + | | <code>halt</code> || halt... |
|- | |- | ||
− | | reset || reset... | + | | <code>reset</code> || reset... |
|- | |- | ||
− | | reset halt || reset, and immediately... halt? | + | | <code>reset halt</code> || reset, and immediately... halt? |
|- | |- | ||
− | | resume [''address''] || resume... (from ''address'') | + | | <code>resume [''address'']</code> || resume... (from ''address'') |
|- | |- | ||
− | | flash write_image erase <''image''> <''address''> || put <''image''> into flash at <''address''> | + | | <code>flash write_image erase <''image''> <''address''></code> || put <''image''> into flash at <''address''> |
|- | |- | ||
− | | load_image <''image''> <''address''> [''bin'' | + | | <code>load_image <''image''> <''address''> [''bin''|''ihex''|''elf''|''s19'']</code> || put <''image''> into SRAM at <''address''> |
|- | |- | ||
− | | exit || exit... | + | | <code>exit</code> || exit... |
|} | |} | ||
Latest revision as of 18:01, 27 July 2012
Contents |
[edit] Download
From git: git://openocd.git.sourceforge.net/gitroot/openocd/openocd
Source: http://sourceforge.net/projects/openocd/files/openocd/
[edit] Build
[edit] Git
# checkout the latest release tag (it may have changed!) git co v0.5.0 # bootstrap ./bootstrap # configure ./configure --enable-maintainer-mode
[edit] Source Package
# configure ./configure
[edit] Build
make
[edit] Install
sudo make install
[edit] Usage
Once OpenOCD is running, you must connect to it using telnet
on port 4444.
This will give you a command prompt, where you can issue the following commands.
Note: When flashing an image, use the 5v power supply, as USB cannot provide enough current
halt |
halt... |
reset |
reset... |
reset halt |
reset, and immediately... halt? |
resume [address] |
resume... (from address) |
flash write_image erase <image> <address> |
put <image> into flash at <address> |
load_image <image> <address> [bin|ihex|elf|s19] |
put <image> into SRAM at <address> |
exit |
exit... |
[edit] Loading
reset halt load_image <image> <address> bin resume <address>
[edit] Flashing
You must halt
, flash
and reset
[edit] Errors
[edit] flash failed
auto erase enabled lm3s.cpu -- clearing lockup after double fault error -302 executing stellaris flash write algorithm flash writing failed with CRIS: 0x0 error writing to flash at address 0x00000000 at offset 0x00000000 in procedure 'flash'
This can occur due to under-current (powered by USB). Either try again, or power using a 5v supply.