Chkconfig
From Attie's Wiki
(Difference between revisions)
m |
m |
||
| Line 1: | Line 1: | ||
<code>chkconfig</code> is used to configure the system services. | <code>chkconfig</code> is used to configure the system services. | ||
| + | |||
| + | {{note|this will not start or stop the service... you must use the service's standard method if you wish to start/stop it now}} | ||
| + | |||
Use it in the following ways: | Use it in the following ways: | ||
| Line 17: | Line 20: | ||
$ chkconfig --list | $ chkconfig --list | ||
</pre> | </pre> | ||
| − | |||
| − | |||
Revision as of 08:37, 31 March 2010
chkconfig is used to configure the system services.
Note: this will not start or stop the service... you must use the service's standard method if you wish to start/stop it now
Use it in the following ways:
To make samba run at boot up:
$ chkconfig --level 2345 smb on
Omitting the --level parameter will apply the changes to all levels.
To disable the samba service:
$ chkconfig smb off
To show the list of services:
$ chkconfig --list
