Atmega328p
From Attie's Wiki
(Difference between revisions)
m (Created page with 'Info on the ATMega328p hardware: <h2>data sheet</h2> http://attie.co.uk/file/ATmega328p.pdf<br> <h2>icsp pins</h2> <h3>connecting to bus pirate</h3> {| |- |align="right" |…') |
m |
||
Line 41: | Line 41: | ||
pin 2 can use the gray wire for 5v instead of 3.3v if your circuit is okay with that | pin 2 can use the gray wire for 5v instead of 3.3v if your circuit is okay with that | ||
− | < | + | <h2>firmwares:</h2> |
The arduino environment comes with a few variations of the firmware (<code><path to arduino>/hardware/arduino/bootloaders/atmega</code>)<br> | The arduino environment comes with a few variations of the firmware (<code><path to arduino>/hardware/arduino/bootloaders/atmega</code>)<br> | ||
This table shows which arduino (that I own...) uses which firmware | This table shows which arduino (that I own...) uses which firmware |
Revision as of 18:38, 1 June 2010
Info on the ATMega328p hardware:
Contents |
data sheet
http://attie.co.uk/file/ATmega328p.pdf
icsp pins
connecting to bus pirate
brown | msio | 1 | 2 | vcc (3.3v) | white | |||
yellow | sck | 3 | 4 | mosi | orange | |||
red | reset | 5 | 6 | gnd | black |
pin 2 can use the gray wire for 5v instead of 3.3v if your circuit is okay with that
firmwares:
The arduino environment comes with a few variations of the firmware (<path to arduino>/hardware/arduino/bootloaders/atmega
)
This table shows which arduino (that I own...) uses which firmware
Filename | Processor | Arduino Boards |
---|---|---|
ATmegaBOOT_168_diecimila.hex | ATMega168 @ 16Mhz | Diecimila, Duemilanove, Nano |
ATmegaBOOT_168_atmega328_pro_8MHz.hex | ATMega328p @ 8Mhz | Pro Mini, Fio |
resources
https://www.mainframe.cx/~ckuethe/avr-c-tutorial/
http://arduino.cc/en/Hacking/PinMapping168
http://hintshop.ludvig.co.nz/show/buspirate-avr-programming/
http://itp.nyu.edu/physcomp/uploads/6pinAVRproghead.jpg
http://dangerousprototypes.com/bus-pirate-manual/
http://www.ladyada.net/library/arduino/bootloader.html